Set the COM Port to 57,600 baud, 8, None, 1, Hardware Flow Control. Configure the RAS login information using ICU.exe 5. Configure the C•CURE 800 Server to accept RAS connections. Configure the controller and cluster using ICU and the C•CURE 800. Serial Connection 1. Connect P6 to the Server COM Port as shown in Table 3. Set the COM Port to 57,600 baud, 8, None, 1, Hardware Flow Control.
Kalkulator
The PEX2S553LP low profile/half-height PCI Express Serial Card turns a PCI Express slot into two RS232 (DB9) serial connections. The card is constructed using a native single chip design that lets you harness the full capability offered by PCI Express (PCIe), while reducing the load applied to the CPU by as much as 48% over conventional bridge chip serial cards. Amazon.com: iStar USA (BPU-2535) 1 x 3.5' to 2 x 2.5' SATA Hot-Swap Mobile Cage: Computers & Accessories.
When you troubleshoot issues with a serial device, there are some quick tests that you can complete to rule out potential problems. You can test to make sure that the following components are working correctly and are not the source of the issue:
Serial cables
Serial ports
Serial devices
To test your setup components, try the following:
Use the serial cable, serial port, and serial device in another setup to see if the problem is with the components or the setup.
Use a different serial cable, serial port, and serial device in your setup to see if the problem persists. Ideally, you should test a component that you know works in another setup.
When you test your cables, it is recommended that you do the following:
5'5 In Cm
Test each cable individually.
Use short cables when you are testing.
When you test the serial ports and serial device, it is recommended that you do the following:
5'5 In Inches
Press the Windows key + R, type devmgmt.msc, and press Enter to open Device Manager. Check to see if your device is listed under Ports (COM & LPT).
Make sure that the COM port number is the correct number for the serial device and that the software being used to connect the computer to the serial device uses the correct COM port number.
If you do not see the COM port number in Device Manager see this FAQ for PCI/PCIe expansion cards: https://www.startech.com/support/faqs/technical-support?topic=expansion-cards#pci-pcie-cannot-boot-os-or-detect-windows
or this FAQ for USB devices: https://www.startech.com/support/faqs/technical-support?topic=expansion-cards#usb-cannot-detect-windowsIf the device is listed with an error, follow the instructions on the website to reinstall the drivers.
5'5 In Cm Conversion
Note: Some serial devices work only if the COM port number is between a certain range. For example, COM1 to COM4.
5'5 Height
Perform a serial loopback test. See this FAQ on how to perform a RS-232 serial loopback test: http://www.startech.com/faq/serial_loopback_test_rs232_windows